Connect & follow youtube youtube Facebook facebook twitter twitter

Your Cart

Shopping cart  Shopping cart
0 Product(s) in cart
Total $0.00
» Checkout
 

Footbag Hacky Sack Decal Installation

Installing Decals

Before you apply your decal clean the surface of the application area with alcohol. Do not allow the alcohol to evaporate on the surface. Separate the transfer tape from backing - the decal is attached to the transfer tape (the top, see-through layer).

Center the decal over the your desired location (truck, window, etc.). Lightly position the decal on the surface, then use a squeegee or credit card to smooth it out, starting from the center and smooth out to the edges. Rubbing the decal with your fingers first will heat up the vinyl and aid in removing the decal from the transfer tape. Peel the transfer tape off at an angle, starting from one of the corners. keep the transfer tape close to the application surface.

NOTE: Do not apply in direct sunlight especially if the surface is hot, as this will cause decal to prematurely stick. The ideal installation temperature is 55-95 degrees. Do not use water or other liquids when installing these decals. Liquid installation will shorten the life of the decal or cause areas underneath to not adhere properly to the surface. Allow the decal to cure on the vehicle for two weeks before reapplying car wax or other protective vehicle or window coatings.

 

Other Products

Wall Decals

Footbag/Hacky Sack

Tshirts

Footbag/Hacky Sack

Car Decals

Footbag/Hacky Sack

 
Our Brands
Advertisement